- Arcade Alley Hoop To Hoop Manual High School Alumni Association
- Arcade Alley Hoop To Hoop Manual High School Louisville
A man was shot in an alley behind 1810 E. 31st Avenue late Wednesday night, according to Denver police spokesman Lt. Matt Murray.Murray said detectives have been able to develop little information about the incident because witnesses have been uncooperative.The victim, who was shot about 10:56 p.m., was taken to the hospital in stable condition.The incident occurred about a block north of the Salvation Army Recreation Center and three blocks northeast of Manual High School.Howard Pankratz: 303-954-1939.
Arcade Alley Hoop To Hoop Manual High School Alumni Association
AssemblyLocate the 'Scoring Arm Assembly' and the backboard. Slip the four already installed screws on the Scoring Arm Assembly into four holes at the bottom of the backboard.Tighten the screws, one at a time, until snug but not overtightened.Cover the newly tightened screws with rubber tape. This prevents any scratches to doors or chairs from exposed metal screws.
Arcade Alley Hoop To Hoop Manual High School Louisville
Setting Up the MachineInstall the clips provided to hang the backboard on the top of the door.Slip the scoring arm through the top middle loop in the net and attach the hoop to the slots in the Scoring Arm Assembly.Unfurl the return mat, clipping the widest portion of the mat to the top of the door on either side of the backboard with the wire to the right.Locate and connect the two wires, located inside the red border. When the two halves are connected, you can plug the wire into the jack on the scoring arm assembly.Insert a AA battery into the 'Scorer/Timer' on the back of the unit.Place a chair with the seat facing the door as close to the door as possible. Clip the scorer to the backrest.Affix the smaller end of the return net to the slots located on the scorer and plug the wire into the jack.Pull the return net taut and turn on the scorer to begin play.